how to do a transient simulation when a switch changes status

Home › Forums › Usage › how to do a transient simulation when a switch changes status

Tagged: 

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 4. May 2023 at 7:40 #7343
    jintonic
    Participant

      Hi,

      I’m trying to figure out the voltage output of an amplifying low-pass filter shown below when S1 is closed at t=10 ns and then opened again at t = 12 ns. However, when I press F2, I got an error message: Error in ‘TR1’: Time step too small at 1e-008 sec: 8.67671e-017. Is there a way to avoid this error?

      Thanks, Jing

      • This topic was modified 5 months ago by maelh. Reason: Convert all remaining http links to https links
    • Author
      Posts
    Viewing 1 post (of 1 total)
    • You must be logged in to reply to this topic.