- This topic has 0 replies, 1 voice, and was last updated 3 years, 9 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hello,
The S-parameter simulation of an active device is typically performed within bias and frequency dependent conditions. The DC and RF results are saved in a standard *.dat file.
It would be helpful to extend the capabilities of the “devices=>S-parameter file (SnP)” component so as to enable it to convert bias and frequency dependent measured DC and S-parameter data.
Wishing a succesful year 2021!
zhu
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.